XTRA
Image is disturbed, unstable or noisy
-Verify compatibility of video/graphic signals with the technical specifications of the projector.
-Check the integrity of cables connecting projector to various sources.
-If the signal source is a terrestrial broadcast (via a VCR) check that the receiving channel has been correctly tuned in and that the aerial system is in good working order.
-Should the problem be present with a signal coming from a
-Adjust the VCR’s tracking control for optimum picture perfor- mance. Ensure the VCR mode is active in the Picture menu.
Incomplete image along borders (vertical and horizontal)
- Compare compatibility of video/graphic signals and techni- cal specifications of your projector.
-Press Auto (on your remote or keypad) to execute automatic adjustments.
-Adjust the horizontal and vertical position of projected image by selecting Position on the Image Adjustments menu.
-Adjust the width and height of image, selecting Aspect in
the Image Adjustments menu.
Image too dark, too pale or unnaturally coloured
-Verify compatibility of video/graphic signals with technical specifications of your projector.
-Go to Picture menu, select and regulate any of the following, accordingly: Contrast, Brightness, Color, and Tint.
-If necessary, reset the Color Temperature and Gamma Correction (found on the Image Adjustments / Advanced Settings menu).
24
Graphic image with poor quality vertical detail
-Verify compatibility of video/graphic signals with technical specifications of your projector.
-Press Auto (on your remote or keypad) to execute automatic adjustments.
-Adjust Frequency and Phase parameters, found in the Image Adjustments menu, to optimise vertical detail of the projected image.
Video Image showing colour misalignment on vertical details
-Verify compatibility of video/graphic signals with technical specifications of your projector.
-Adjust Y/C Delay settings in the Image Adjustments / Advanced Settings to reduce colour misalignment. For best results use an external colour bar test pattern source.
Remote control does not work
-Check the batteries and for correct polarity.
-Ensure that the area between the infrared sensor (front of projector) and the remote control is free of obstruction.
-Ensure that infrared sensors (front and rear of projector) are not exposed to intense light levels.
