Sima Products SUR-35 user manual Controlling the Device, Operation, Auto search, Button

Operation SUR-35 User Manual

Controlling the Device

Make sure the SUR-35 is pointing at the device you are trying to control and simply press the button you want to send:

•Press the Touch Screen buttons.

•Press one of the rubber buttons on the bottom half of the SUR-35’s.

Note - Record Button Must Be Held Down for 3 Seconds: As a safety feature, the record button needs to be pressed for 3 seconds. This is to prevent accidentally pressing the VCR record button and overwriting a tape.

Ch.

4

Page

SUR-35 User Manual	Auto search
To use automatic search:
Automatic Search
A1. Make sure the SUR-35 is
pointing at the device you want
to control and press the AUTO
button.
A2. The AUTO button will flash	A1
while the SUR-35 automatically
cycles through the codes. A

POWER command is sent with

each code. The correct code will turn your TV on if it is off. The code numbers will be displayed in the upper right-hand corner display window. Wait for the device to turn on and then press the POWER button to stop the automatic search. The last tried code will be displayed in the upper right hand corner. You can test this code by pressing the POWER button. (You may need to press TUNING Down and try the previous few codes.) The code numbers will continually repeat. If the sequence begins again without turning your device on, it did not find your code. Stop by pressing EXIT if it did not find your code.

A3

A3. Once your device turns on or off when you press the POWER button, press the OK button to return to the SETUP menu.

Ch.

3

Page

36 25