Singer 9910 Threading the Machine, Preparing to Thread Machine, Threading the Upper Thread

THREADING THE MACHINE

A. PREPARING TO THREAD MACHINE

1.Raise the presser foot lifter.

2.Press the needle up/down button and set the needle in up position.

(Keep this position until needle eye threading.) Open the top cover and set spool as below.

B. SETTING SPOOL OF THREAD ON

SPOOL PIN

1.Pull up the left end of spool pin and set the spool of thread on spool pin.

2.Set the spool cap on spool pin as far as it will go.

a: Reverse spool cap direction according to the size of spool.

b. Use the small spool cap when you use cross wound thread. Leave small opening between cap and spool as illustration.

C. THREADING THE UPPER THREAD
1.	Hold thread in both hands and pass thread to
	the guide from front opening.
2.	Bring thread backward and pass through the slit
	from right to left.
3.	Bring thread to the left and pull down thread
	toward you along the slit.
4.	Pull up thread.
5.	To thread the take-up lever, draw thread up and
	bring thread back down again from right to left
	along the slit.
6.	Pull thread downward along the slit.
7.	Draw thread through thread guide from right
	side opening.
8.	Pass through needle eye from front to back.
	Refer to next page for instructions on how to
	use needle threader.
28
9910EFSt.pm6		28	2003.9.10, 8:46 PM