Ski-Doo RXP Series, GTX Series, GTI Series, RXT Series, WAKE Series 119, Beeper Code Information

		MONITORING SYSTEM
PILOT	MESSAGE DISPLAY	DESCRIPTION
LAMPS (ON)
	OIL	Low oil pressure
-	MAINTENANCE	Maintenance on supercharger required
	SUPERCHARGER
-	SENSOR	Sensor failure (vehicle electronic equipment)
-	KEY	Invalid DESS key
-	L KEY	DESS learning key active

NOTICE

engine.

Running engine with low oil pressure may severely damage the

Beeper Code Information

BEEPER CODES	DESCRIPTION
	Bad DESS system connection.
	Reinstall DESS key correctly over post.
	Wrong DESS key.
	Use a DESS key that has been programmed for the
	watercraft.
1 Long Beep	Defective DESS key.
	Use another programmed DESS key.
(while installing DESS
	Dried salt water in DESS key.
key on watercraft post)
	Clean DESS key to remove salt water.
	Defective DESS post.
	Refer to an authorized Sea-Doo dealer.
	Improper operation of ECM or defective wiring
	harness.
	Refer to an authorized Sea-Doo dealer.
1 Short Beep	ECM has been mistakenly set to onboard diagnostic
	mode.
followed by 1 long beep
	Remove and reinstall DESS key.
4 Short Beeps	DESS key has been left on its post without starting
	engine or after engine was stopped.
at different interval for
	To prevent battery discharge, remove the DESS key from
4 hours
	its post.
	Watercraft is upside down.
A 2 Seconds Beep	Turn watercraft upright. Refer to SPECIAL PROCEDURES.
every 15 minutes interval	Engine management system fault.
	Refer to an authorized Sea-Doo dealer.

______________ 119