Ski-Doo GTX Series, RXP Series, GTI Series, RXT Series, WAKE Series PRE-RIDE Inspection, Operation

PRE-RIDE INSPECTION

WARNING

The pre-ride inspection is very important prior to operating the watercraft. Always check the proper operation of critical controls, safety features and mechanical components before starting. If not done as specified here, severe injury or death might occur. Bring all safety equipment required by local laws.

For more detailed information on these items, refer to the applicable sections.

WARNING

Engine should be off and the DESS key should always be removed from its post prior to verifying any of the following points. Only start watercraft once all items have been checked and operate properly.

ITEM	OPERATION	✓
Hull	Inspect.
Jet pump water intake	Inspect/clean.
Bilge	Drain. Ensure plugs are secured.
Battery	Inspect tightness of cables and retaining
	fasteners.
Fuel tank	Refill.
Engine compartment	Verify for leaks or gasoline odor. Verify fuel
	exhaust components integrity.
Engine oil level	Check/refill.
Engine coolant level	Check/refill.
Steering system and side	Check operation.
vanes (O.P.A.S.™)
Throttle system	Check operation.
Shifter system	Check operation.
Variable Trim System (VTS)	Check operation.
Storage compartment covers	Ensure they are closed and latched.
and seat
Self-contained removable	Ensure it is installed on vehicle and properly
storage bin	closed and latched.
	– Ensure rack is installed properly.
Wakeboard rack	– Make sure bungee cords are in good condition.
	– Ensure wakeboard is installed properly.
Ski/wakeboard post	Inspect and check operation.
DESS post and engine	Check operation.
start/stop button
Ballast tanks	Ensure tanks are properly installed and latched.

________ SAFETY INFORMATION ________ 33