Yamaha RX-SL100RDS owner manual Setting manufacturer codes, Default codes, Setting a code

Setting manufacturer codes

Once you set the appropriate manufacturer codes, you can use this remote to control your other components. Note that some buttons may not correctly operate the selected component. Use the input selector buttons to select the component you want to operate. The remote control automatically switches to the appropriate control mode for that component.

■Default codes

The following table shows the default component (Library: component category) and the manufacturer code for each area.

Input area	Manufacturer	Code
TV (DTV/CBL)	YAMAHA	299
VCR	YAMAHA	399
DVD (DVD/CD)	YAMAHA	699

Note

You may not be able to operate your YAMAHA component even if a YAMAHA manufacturer code is initially set as listed above. In this case, try to set another YAMAHA manufacturer code.

■Setting a code

1Hold down CODE SET while doing steps 2 and 3.

CODE SET

2Press an input selector button to select the source component you want to set up.

DVD/CD	VCR	VIDEO 1
DTV/CBL	TUNER	VIDEO 2

REMOTE CONTROL FEATURES

3Press the numeric buttons to enter the three- digit manufacturer code for the component to be used, then release CODE SET.

HALL JAZZ ROCK ENTERTAIN

1	2	3	4
MUSIC	TV THTR	MOVIE 1	MOVIE 2

5 6 7 8

q/DTS NIGHT EX/ES STEREO

9 0 +10 ENT

EFFECT

Refer to “LIST OF MANUFACTURER CODES” at the end of this manual.

y

To reset an input area’s manufacturer code to the factory default, input the default code (see “Default codes” above) in step 3.

Notes

•If the manufacturer of your component has more than one code, try each of them until you find the correct one.

•If you wait for more than 10 seconds during step 3, the setup process is canceled. If this happens, start over from step 2.

•Replace the batteries frequently. The settings may be lost after two minutes without power supply.

OPERATION ADVANCED

English

47