Yamaha RX-SL100RDS Speaker Level, Press k/n repeatedly to select Room Size, then press ENTER

6Press k/n repeatedly to select Room Size, then press ENTER.

Use k/nto select the size of the room you have installed your speakers in, then press ENTER. Roughly speaking, the room sizes are defined as follows:

[U.S.A. and Canada models]

S (small)	16 x 13 ft, 200 sq. ft
	(4.8 x 4.0 m, 20 m2)
M (medium)	20 x 16 ft, 300 sq. ft
	(6.3 x 5.0 m, 30 m2)
L (large)	26 x 19 ft, 450 sq. ft
	(7.9 x 5.8 m, 45 m2)
[Other models]
S (small)	3.6 x 2.8 m, 10 m2
M (medium)	4.8 x 4.0 m, 20 m2
L (large)	6.3 x 5.0 m, 30 m2

7Press k/n repeatedly to select Subwoofer

Set, then press ENTER.

Use k/nto select Yes or None, then press ENTER.

Yes	If you have a subwoofer in your system.
None	If you do not have a subwoofer in your system.

8Press k/n repeatedly to select Speaker Num, then press ENTER.

Use k/nto select the number of speakers connected to the unit, then press ENTER. The choices vary as follows:

Choices	Display	Speakers
2 spk	L C R	Front L/R
	SL SB SR

	Front L/R, Center
3 spk	L C R
	SL SB SR

	Front L/R, Surround L/R
4 spk	L C R
	SL SB SR

	Front L/R, Center, Surround L/R
5 spk	L C R
	SL SB SR

6 spk	L C R		Front L/R, Center, Surround L/R,
			Surround back
	SL	SB SR

BASIC SETUP

9After you have finished the settings, press n repeatedly to select Setting OK?, then press

ENTER.

Use k/n to select Set or Cancel, then press ENTER.

Set	To apply the changes and start the test
	tone.
Cancel	To cancel the changes and return to
	Speaker Set Up.

Use the test tone to check the speaker levels.

If you selected Set, the display changes to “CHECK: Test Tone”, and the unit outputs a test tone from each speaker in turn. When the test tone begins, the display

changes to “CHECK OK: YES”.

Notes

•The unit cycles the test tone around each of the speakers in turn twice.

•The indicator of the speaker currently outputting the test tone flashes on the front panel display.

10Press k/n repeatedly to select Yes or No, then press ENTER.

Yes	To return to Speaker Set Up.
No	To enter Speaker Level.

■Speaker Level

Use this menu to compare and adjust the test tone output from each speaker to the output from the left front (or left surround) speaker so that the volume level for all speakers is identical.

	Front
Speaker Set Up	Center
Speaker Level	Sur L
	Sur R
	Sur Back

Press ENTER to enter the Speaker Level adjustment menu, then press k/n to select a speaker and adjust the balance using l / h.

The unit outputs the test tone from the selected speaker and the left front (or left surround) speaker in turn. The indicator of the speaker currently outputting the test tone flashes on the front panel display.

PREPARATION

English

17