Yamaha RX-SL100RDS owner manual Displaying information about the input source, Press AMP

ADVANCED OPERATIONS

■Displaying information about the input

source

You can display the type, format and sampling frequency of the current input signal.

1Press AMP.

2Press STEREO/EFFECT so that “STEREO” appears in the display.

STEREO

ENT

EFFECT

Manually adjusting speaker levels

You can adjust the output level of each speaker while listening to a music source. Please note that this operation will override the level adjustments made in the Speaker Level section of BASIC setup (see page 17) and “Using the test tone” (page 37).

1Press AMP to select the AMP mode.

AMP

3Press k/n to display the following information about the input signal.

ENTER

(Format)	Signal format display. When the unit
	cannot detect a digital signal it
	automatically switches to analog input.
in	Number of source channels in the input
	signal. For example, a multi-channel
	soundtrack with 3 front channels, 2
	surround channels and LFE, is
	displayed as “3/2/LFE”.
fs	Sampling frequency. When the unit is
	unable to detect the sampling
	frequency “Unknown” appears.
rate	Bit rate. When the unit is unable to
	detect the bit rate “Unknown” appears.
flg	Flag data encoded with DTS or Dolby
	Digital signals that cue this unit to
	automatically switch decoders.

2Press LEVEL repeatedly to select the speaker you want to adjust.

	TITLE
	LEVEL
FRONT L	Front left speaker level
CENTER SP	Center speaker level
FRONT R	Front right speaker level
SUR.R	Surround right speaker level
SUR.B	Surround back speaker level
SUR.L	Surround left speaker level
SWFR	Subwoofer level

y

Once you press LEVEL, you can also select the speaker by pressing k/non the remote control.

3Press l / h to adjust the speaker output level.

• The control range is from +10 dB to –10 dB.

ENTER

Note

When inputting digital signals with sampling frequencies higher than 48 kHz, only the subwoofer level can be adjusted.

36