Skil 3320-01 manual Operating Adjustments, Install the belt Fig, Align the belt pulleys Fig

!		Operating Adjustments
	WARNING To reduce the risk of injury:
• Turn switch “OFF” and remove plug from the power				FIG. 14
source before making adjustments.					1
• Follow instructions carefully and wear eye protection to
avoid thrown parts due to spring release.					3
• Never operate drill press with pulley cover open
	Install the belt (Fig. 14)				2
1. Open the pulley and belt cover (1).
2. Loosen the belt tension lock knobs (2) on both sides				4	1/2"
	of the drill press.
3. Slide the motor (3) as close to the drill press head as
	possible.	(4) on the motor pulley	(5) and the		5
4. Place a belt
	spindle pulley	(6) in the proper position for the desired		6
	speed (see Fig. 17).
5. Pull the motor away from the drill press head until the
	belt is properly tensioned. Tighten the belt tension
	lock knobs (2).
Note: The belt (4) should be tight enough to prevent					3
slippage. Correct tension is set if the belt flexes about				FIG. 15
1/2" when thumb pressure is applied at the midpoint of
the belt between the pulleys.
	Align the belt pulleys (Fig. 15)				4
1. Check the alignment of the pulleys with a straight edge
	(1) (such as a ruler, level, or framing square) by laying
	the straight edge across the top of the pulleys (2).
2. If the pulleys are NOT aligned, release belt tension by
	loosening the belt tension lock knobs		(3) on both
	sides of the head.				1
3. Loosen the motor mount nuts (4) with an adjustable
	wrench, and lower or raise the motor until the pulleys
	are aligned.
4. Tighten the motor mount nuts (4) with an adjustable
	wrench to maintain the position.				2
5. Lock the motor for the proper belt tension and tighten
	the tension lock knobs (3).		Spindle speeds (Fig. 16)
This drill press offers 5 spindle speeds from 570 to 3050				positioned on the largest motor pulley step and the
RPM. The highest speed is obtained when the belt is				smallest spindle pulley stop.

FIG. 16

13.