Skil 3320-01 manual Laser safety, This Drill Press has 5 Speeds 570 RPM, Think Safety

Additional Safety Rules

14. NOTE AND FOLLOW THE SAFETY WARNINGS AND INSTRUCTIONS THAT APPEAR ON THE PANEL ON THE RIGHT SIDE OF THE DRILL PRESS HEAD:

15. THIS DRILL PRESS HAS 5 SPEEDS: 570 RPM,

900 RPM, 1390 RPM, 2050 RPM AND 3050 RPM. See inside of guard for specific placement of belt on pulleys.

16. THINK SAFETY

SAFETY IS A COMBINATION OF OPERATOR COM- MON SENSE AND ALERTNESS AT ALL TIMES WHEN THE DRILL PRESS IS BEING USED.

!Do not allow familiarity (gained from frequent use of your drill press) to become commonplaceWARNING . Always remember that a careless fraction

of a second is sufficient to inflict severe injury.

The operation of any power tool can result in foreign objects being thrown into the eyes, which can result in severe eye damage. Always wear safety goggles that comply with ANSI Z87.1 (shown on

Package) before commencing power tool operation.

!Some dust created by power sanding, sawing, grinding, drilling, andWARNINGother construction activities contains

chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:

• Lead from lead-based paints,

• Crystalline silica from bricks and cement and other masonry products, and

• Arsenic and chromium from chemically treated lumber.

Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.

Laser safety

!To reduce the risk of injury:

1. DoWARNINGnot stare directly at the laser beam. Eye damage may occur if you deliberately stare into the beam.

2. The laser light beam used in this system is Class II with maximum 1 mW and 650 nm wavelengths. AVOID DIRECT EYE EXPOSURE.

3. The laser must be used and maintained in accordance with the manufacturer’s instructions:

• Never aim the beam at any person or an object other than the workpiece.

• Do not project the laser beam into the eyes of others.

• Always ensure the laser beam is aimed at a workpiece without reflective surfaces as the laser beam could be projected into your eyes or the eyes of others.

		Use of controls or adjustments or
!	CAUTION
		performance of procedures other than

those specified herein may result in hazardous radiation exposure.

5.