Skil 3320-01 manual Mount the drill press Fig, Install the chuck Fig, Remove the chuck Fig

			Assembly and adjustments
	Mount the drill press (Fig. 11)			FIG. 11	1
Your drill press must be securely fastened through the
mounting holes (1) to a stand or work bench with heavy-
duty fasteners. This will prevent the drill press
from tipping over, sliding, or walking during operation.
IMPORTANT: If the stand or workbench has a
tendency to move during operation, fasten it securely to
the floor.		Install the chuck (Fig. 12)
1. Inspect and clean the taper hole in the chuck (1) and
	the spindle (2). Remove all grease, coatings, and
	particles from the chuck and spindle surfaces with a			FIG. 12
	clean cloth.				1	2
2. Open the chuck jaws (3) by turning the chuck barrel
	clockwise by hand. Make sure the jaws are					3
	completely recessed inside the chuck.
3. Seat the chuck on the spindle by placing a block of							4
	wood (4)	under the chuck (1) and tapping the wood
	with a hammer (5) or tap the chuck with a rubber					5
!	mallet.		To avoid damaging the chuck, make
	CAUTION		sure the jaws are completely recessed
into the chuck. Do not use a metal hammer directly
to drive the chuck into the spindle.
	Remove the chuck (Fig. 13)			FIG. 13
1. Turn the feed handles (1) to lower the chuck (2) to the
	lowest position.
2. Place a ball joint separator (not shown) above the					3
	chuck (3) and tap it lightly with a hammer (4) to cause			4
	the chuck to drop from the spindle.					5
Note: To avoid possible damage, be prepared to catch					2
the chuck as it falls.

12.