Assembly and adjustments
!DO NOT STARE DIRECTLY AT THE LASER BEAM! A hazard may exist if you deliberately WARNING stare into the beam. Please observe all safety rules as follows:
•The laser shall be used and maintained in accordance with the manufacturer's instructions.
•Never aim the beam at any person or an object other than the workpiece.
•Do not project the laser beam into the eyes of others.
•Always ensure the laser beam is aimed at a workpiece with out reflective surfaces as the laser beam could be projected into your eyes or the eyes of others.
Laser switch (Fig. 25)
The laser switch (1) is located on the left side of the drill press housing.
Adjust the laser line (Fig. 25 and 26) 1. Place a workpiece on the table.
2. Turn the laser switch (1) to the ON position.
3. Lower the drill bit to meet the workpiece (2). The two laser lines should cross where the drill meets the workpiece.
4. If the laser needs to be adjusted:
a. Using a 3 mm hex wrench, turn the laser adjustment
1 | FIG. 25 |
|
3 
4 
hex screws (3) counterclockwise.
b. Move the laser light housing (4) until the two lines intersect where the drill meets the workpiece. DO NOT stare directly at the laser lines.
5.
2
FIG. 26
Operation
Switches (Fig. 27) (1) 1. To turn the drill press ON, insert the safety key
into the switch housing (2). As a safety feature, the switch cannot be turned ON without the key.
2. Flip the switch upward to the ON position.
3. To turn the drill press OFF, move the switch to the down position.
4. To lock the switch in the OFF position, remove the safety key from the switch. Store the key in a safe place.
FIG. 27 |
|
|
| 2 | F |
1 |
| |
| 3 |
|
17. |
|
|
