Skil 3800-02 manual Service, Carbon Brushes, Motor Brush Replacement

Maintenance and
Lubrication	FIG. 32

Service

!Preventive maintenance performed by WARNING unauthorized personnel may result in

misplacing of internal wires and components which could cause serious hazard. We recommend that all tool service be performed by a Skil Factory Service Center or Authorized Skil Service Station.

Carbon Brushes

The brushes and commutator in your tool have been engineered for many hours of dependable service. To maintain peak efficiency of the motor, we recommend every two to six months the brushes be examined. Only genuine Skil replacement brushes specially designed for your tool should be used.

Motor Brush Replacement

To Inspect or Replace Brushes:

1.Unplug the saw.

!	CAUTION	The brush cap is spring loaded by the
		brush assembly.

2.Remove the brush cap on the motor using a wide flat blade screwdriver.

3.Pull out the brush 1 (Figure 32). Repeat for the opposite side.

NOTE: If installing the existing brush or brushes, make sure the brush goes in the same way it came out. Otherwise a break-in period will occur that will reduce motor performance and increase brush wear.

4.Install new brush. The two (2) tabs on the brush terminal 2 go in the same hole the carbon part fits into.

5.Tighten the brush cap but do not overtighten.

1

2

67