Skil 3800-02 manual Switch Activation

Basic Saw Operations

Auxiliary Fence - Certain types of molding need a fence face extension because of the size and position of the workpiece. Holes are provided in the fence to attach an auxiliary fence. The auxiliary fence is used with the saw in the 0° bevel position only.

1.Place a piece of wood 1 against the miter saw fence (Figure 21). (Wood can have a maximum height as high as the fence on the left. For the right side, check that head assembly does not interfere with auxiliary fence.)

2.Mark the locations of the support holes on the wood from the back side of the fence.

3.Drill and countersink the holes on the front of the support board.

4.Attach the auxiliary fence using four (4) flat head machine screws 2. Make a full depth cut to create the blade slot 3. Check for interference between the auxiliary fence and the lower blade guard. Make adjustments as necessary.

!Check for interference from any WARNING components.

Switch Activation

To reduce the likelihood of accidental start-up, the switch is equipped with safety buttons 4 that must be depressed before the trigger 5 can be activated (Figure 22). The safety buttons are designed to be activated by the right or left thumb pushing in the left to right direction. When either safety button is depressed, the trigger is unlocked and it can be pulled to activate the motor. Once the trigger is activated, release the safety button so it can automatically engage and lock the switch upon release of the trigger.

!Avoid positioning the palm of your WARNING hand over the safety button. Pressure

from the palm of your hand may unintentionally unlock the safety button or prevent it from automatically engaging and locking the switch upon release of the trigger.

NOTE: Switch can accommodate a padlock with a long shackle of up to 1/4” in diameter (not provided with compound miter saw) to prevent unauthorized use.

FIG. 21

3

1

2

2

4

FIG. 22

5

48