SMC Networks 10/100/1000 SMCGS8P-Smart manual Line Commands

COMMAND LINE INTERFACE

Line Commands

You can access the onboard configuration program by attaching a VT100 compatible device to the server’s serial port. These commands are used to set communication parameters for the serial port or a virtual terminal. Note that Telnet is considered a virtual terminal connection, and the only commands that apply to Telnet include exec-timeoutand password-thresh.

Command	Function	Mode	Page
line	Identifies a specific line for configuration	GC	3-81
	and starts the line configuration mode
login	Enables password checking at login	LC	3-82
password	Specifies a password on a line	LC	3-83
exec-timeout	Sets the interval that the command	LC	3-84
	interpreter waits until user input is
	detected
password-	Sets the password intrusion threshold,	LC	3-85
thresh	which limits the number of failed logon
	attempts
silent-time	Sets the amount of time the management	LC	3-86
	console is inaccessible after the number of
	unsuccessful logon attempts exceeds the
	threshold set by the password-thresh
	command
databits	Sets the number of data bits per character	LC	3-87
	that are interpreted and generated by
	hardware
parity	Defines the generation of a parity bit	LC	3-88
speed	Sets the terminal baud rate	LC	3-89
stopbits	Sets the number of the stop bits	LC	3-90
	transmitted per byte
show line	Displays a terminal line's parameters	NE,	3-90
		PE

3-80