C
OMMAND

L

INE

I

NTERFACE

3-154

Command Usage
If enabled, the switch will serve as querier if elected. The
querier is responsible for asking hosts if they want to receive
multicast traffic.
Example

ip igmp snooping query-count

Use this command to configure the query count. Use the no form
to restore the default.
Syntax
ip igmp snooping query-count count
no ip igmp snooping query-count
count - The maximum number of queries issued for which
there has been no response before the switch takes action
to solicit reports. (Range: 2-10)
Default Setting
2 times
Command Mode
Global Configuration
Command Usage
The query count defines how long the querier waits for a
response from a multicast client before taking action. If a
querier has sent a number of queries defined by this command,
but a client has not responded, a countdown timer is started
using the time defined by ip igmp snooping query-max-
response-time. If the countdown finishes, and the client still
has not responded, then that client is considered to have left
the multicast group.
Console(config)#ip igmp snooping querier
Console(config)#
b_mgmt.book Page 154 Tuesday, July 8, 2003 5:24 PM