S
WITCH

M

ANAGEMENT

1-14

Due to the size limit of the flash memory, the switch supports only
two operation code files. However, you can have as many
diagnostic code files and configuration files as available flash
memory space allows.
In the system flash memory, one file of each type must be set as
the start-up file. During a system boot, the diagnostic and
operation code files set as the start-up file are run, and then the
start-up configuration file is loaded.
Note that configuration files should be downloaded using a file
namethat reflects the contents or usage of the file settings. If you
download directly to the running-config, the system will reboot,
and the settings will have to be copied from the running-config to
a permanent file.

System Defaults

The switch’s system defaults are provided in the configuration file
“Factory_Default_Config.cfg.” To reset the switch defaults, this file
should be set as the startup configuration file. See “Saving or
Restoring Configuration Settings” on page 2-28.
The following table lists some of the basic system defaults.
Function Parameter Default
IP Settings Management VLAN 1
DHCP Enabled
BOOTP Disabled
User Specified Disabled
IP Address 0.0.0.0
Subnet Mask 255.0.0.0
Default Gateway 0.0.0.0
b_mgmt.book Page 14 Tuesday, July 8, 2003 5:24 PM