SMC Networks 10/100/1000 SMCGS8P-Smart P, C, 3-175, show port monitor

M IRROR P ORT C OMMANDS
3-175
Command Usage
• You can mirror traffic from any source port to a destination port
for real-time analysis. You can then attach a logic analyzer or
RMON probe to the destination port and study the traffic
crossing the source port in a completely unobtrusive manner.
• The destination port is set by specifying an Ethernet interface.
• The source and destination port speeds should match,
otherwise traffic may be dropped from the source port.
• You can create only one port mirror session.
• The source and destination ports have to be either both in the
port range 1-12 or both in the port range 13-24.
Example
The following example configures the switch to mirror all packets
from port 6 to port 11:
Related Commands
show port monitor (3-175)
show port monitor
Use this command to display mirror information.
Syntax
show port monitor [interface]
interface
•ethernet unit/port (source port)
-unit - Switch (unit 1).
-port - Port number.
Console(config)#interface ethernet 1/11
Console(config-if)#port monitor ethernet 1/6 both
Console(config-if)#
b_mgmt.book Page 175 Tuesday, July 8, 2003 5:24 PM