INSTALLING AND CONFIGURING NETWORK DRIVERS

9.Click on “Next” and then “Next” again when prompted to “Install Network Components.” When prompted for Windows NT files, type the path to your Windows NT files on CD-ROM (e.g., D:\WINNT), or change the path to those files on your hard drive, and click on “OK.”

10.You are presented with the “Network Card Setup” window where you can specify the network card data rate. “AUTONEGOTIATE” is the recommended setting for the EtherPower II 10/100 network card. Select “Continue” after verifying network card settings.

11.Click on “Next” and then “Next” again when prompted to “Start the Network.”

12.Enter the “Workgroup” or “Domain” names (optional) when prompted and click on “Next.”

13.Select “Finish” when prompted and click on “Yes” when prompted to reboot. Remove the SuperDisk.

For Further Customization

You can modify card settings via the “Network” applet. Install additional protocols and network components by selecting the appropriate folder (e.g., Customizing Protocols, Services, Identification, or Bindings).

Secondary installation

Follow this procedure if you've already installed another network card, configured Windows NT Networking, or loaded another driver.

1.Install the SMC network card (if not already installed), attach the network cable, and boot Windows NT.

3-5