SMC Networks SMCWUSBT-G manual Level, Network Type, Wireless Mode, Ad Hoc Network

Wireless USB 2.0 Adapter

Advanced Tab

In the Utility, access the Advanced tab by clicking New or Modify on the Profile Management tab, then clicking the Advanced tab in Profile Management.

Edit the fields in the Advanced tab of Profile Management to configure the profile. Make sure to also edit the General and Security tabs.

Transmit Power	Selects the transmit power level for 80211b/g or 802.11a in mW. Actual
Level	transmit power may be limited by regulatory domain or hardware
	limitations.

Power Save	Specify:
Mode	Maximum mode causes the access point to buffer incoming messages
	for the wireless adapter. The adapter up periodically polls the access
	point to see if any messages are waiting.
	Normal uses maximum when retrieving a large number of packets, then
	switches back to power save mode after retrieving the packets.
	Off turns power saving off, thus powering up the wireless adapter
	continuously for a short message response time.
Network Type	Specifies the network as either infrastructure (access point mode) or ad
	hoc.
802.11b Preamble	Specifies the preamble setting in 802.11b. The default setting is Short
	& Long (access point mode), which allows both short and long headers
	in the 802.11b frames. The adapter can only use short radio headers if
	the access point supports and uses them. Set to Long Only to override
	allowing short frames.
Wireless Mode	Specifies 5GHz 54 Mbps, 2.4 GHz 54 Mbps, 2.4 GHz 11 Mbps, or
	Super A/G operation in an access point network.
	The wireless adapter must match the wireless mode of the access point
	it associates to.
Wireless Mode	Specifies 5GHz 54 Mbps, 5GHz 108 Mbps, or 2.4 GHz 54/11 Mbps to
when Starting an	start an ad hoc network if no matching network name is found after
Ad Hoc Network	scanning all available modes.
	This mode also allows selection of the channel the wireless adapter
	uses. The channels available depend on the regulatory domain. If the
	adapter finds no other ad hoc adapters, this selection specifies which
	channel with the adapter starts the ad hoc network with.

22