Smeg DI614H Changing The Programme, Stopping A Programme, End Of Programme, Removing The Dishes

Instructions for the User EN

7.3 CHANGING THE PROGRAMME

To change a programme while it is running, proceed as follows:

•press button (F) to set the programme in pause status;

•open the door and select the new button using button (B);

•close the door; the changes relating to the new programme will appear on the DISPLAY (G).

7.4 STOPPING A PROGRAMME

•To stop a programme while it is running, it must first be interrupted by pressing button (F);

•then open the door and press button (B) in repetition until you obtain “Annul cycle 0”;

•close the door. “Empty tank” will appear on the DISPLAY (G) and the dishwasher will start to pump out the water. This will be completed in about 1 minute and “Progr. End” will appear on the top line of the display.

Before the door is closed, a long washing time will appear alongside "Empty tank”. This is not a malfunction but simply a stage in the time update process; the time will be corrected to 1 minute when the door is closed.

END OF PROGRAMME

At the end of the programme the buzzer sounds (if enabled), after which the temperature and programme name will alternate with “Progr. End” on the top line of the DISPLAY (G); the bottom line continues to show “Duration XX min”.

REMOVING THE DISHES

At the end of the washing programme, wait at least 20 minutes before removing the dishes, to allow them to cool. To ensure that any drops of water left in the top basket cannot drip onto the dishes still in the bottom basket, you are advised always to empty the bottom basket first, followed by the top basket.

19