Smeg DI614H Troubleshooting, Acquastop failure, Safety device tripped, Heating k.o, Drain blocked

EN Instructions for the User

11. Troubleshooting

The dishwasher has an autodiagnosis system capable of detecting and indicating a preset series of possible malfunctions.

If a malfunction occurs, the relative name indicating the possible cause of the malfunction appears on the DISPLAY (G). The following table summarises the main possible malfunctions and provides brief descriptions.

TABLE OF MALFUNCTIONS DETECTED BY THE AUTODIAGNOSIS SYSTEM

MALFUNCTION - DESCRIPTION

Acquastop failure

The anti-flooding system has been activated (for the relevant models only). The system is tripped in case of water leaks. Contact the after-sales service.

Safety device tripped

The system which limits the water level inside the dishwasher has been tripped. Interrupt the programme and switch off the dishwasher. Switch the dishwasher back on, programme it again and start the washing cycle. If the problem persists, contact the after-sales service.

Heating k.o.

The water is not heated or the heating parameters are not correct. Repeat the washing programme; if the problem persists, contact the after-sales service.

Temperature sensor k.o.

Interrupt the programme and switch off the dishwasher. Switch the dishwasher back on, programme it again and start the washing cycle. If the problem persists, contact the after-sales service.

Tap turned off

The appliance does not take in water or does not do so correctly. Check that the water connections are correct, the water intake tap is turned on and the filter is not fouled. If the problem persists, contact the after-sales service.

Drain blocked

If the appliance does not pump out the water or does not do so correctly. Check that the drain hose is not kinked or crushed and that the syphon and filter are not fouled. If the problem persists, contact the after-sales service.

39