SMSC USB2640, USB2640i 7.3.3.19E6h: Config Data Byte 3 (CFG_DAT_BYT3)

Ultra Fast USB 2.0 Multi-Format Flash Media Controller/USB Hub Combo

BIT
NUMBER	BIT NAME	DESCRIPTION

3	COMPOUND	Compound Device: Allows OEM to indicate that the hub is part of a
		compound (see the USB Specification for definition) device. The
		applicable port(s) must also be defined as having a "Non-Removable
		Device".
		Note: When configured via strapping options, declaring a port as non-
		removable automatically causes the hub controller to report that it
		is part of a compound device.
		0 = No
		1 = Yes, the hub is part of a compound device
2:0	Always reads ‘0’.	Always reads ‘0’.

7.3.3.19E6h: Config Data Byte 3 (CFG_DAT_BYT3)

BIT
NUMBER	BIT NAME	DESCRIPTION
7:4	Reserved	Always reads ‘0’.
3	PRTMAP_EN	Port Re-mapping enable: Selects the method used by the hub to assign port
		numbers and disable ports.
		‘0’ = Standard Mode. Strap options or the following registers are used to
		define which ports are enabled, and the ports are mapped as Port ‘n’ on the
		jub is reported as Port ‘n’ to the host, unless one of the ports is disabled,
		then the higher numbered ports are remapped in order to report contiguous
		port numbers to the host.
		Register 300Ah: Port Disable For Self-Powered Operation (Reset = 0x00).
		Register 300Bh: Port Disable For Bus-Powered Operation (Reset = 0x00).
		‘1’ = Port Re-map mode. The mode enables remapping via the registers
		defined below.
		Register 30FBh: Port Remap 12 (Reset = 0x00)
		Register 30FCh: Port Remap 3 (Reset = 0x00)
2:0	Reserved	Always reads ‘0’.

SMSC USB2640/USB2641	39	Revision 2.0 (10-03-08)
	DATASHEET