|
|
|
|
|
| Operation |
Stopping the Mower |
|
| Cutting Height Adjustment | |||
1. Stop forward motion of the mower by releasing the | ! | WARNING |
| |||
wheel drive control. |
|
| ! | |||
2. Stop the engine and blade by releasing the blade | DO NOT attempt any maintenance, adjustments or | |||||
control. |
|
|
| service with engine and blade running. STOP engine | ||
Handle Height Adjustment | and blade. Disconnect spark plug wire and secure | |||||
HOT. Avoid serious burns, allow sufficient time for all | ||||||
|
|
|
| away from spark plug. Engine and components are | ||
! | WARNING |
| ! | components to cool. |
| |
DO NOT attempt any maintenance, adjustments or | 1. Pull the height adjusting latch (A, Figure 6) out- | |||||
service with engine and blade running. STOP engine | ward and move to the desired cutting height. | |||||
and blade. Disconnect spark plug wire and secure |
|
|
| |||
away from spark plug. Engine and components are |
|
|
| |||
HOT. Avoid serious burns, allow sufficient time for all |
|
|
| |||
components to cool. |
|
|
|
|
| |
The height of the mower handle can be adjusted as fol- |
|
|
| |||
lows: |
|
| each |
|
|
|
1. Loosen the lower nuts (A, Figure 5) |
|
|
| |||
lower handle. |
| Reproduction |
| |||
2. Move the handle assembly (B) up or down until |
|
|
| |||
the desired position is achieved. |
|
|
|
|
| |
3. Tighten the lower nuts on each lower handle to |
|
| A | |||
maintain the desired position. |
|
|
|
| ||
|
|
|
| Fig | re 6: Adjusting cutting height |
|
|
|
|
| 2. Set all wheels at the same cutting height. The | ||
|
|
|
| highest cutting position is Notch 7 (Figure 7). The | ||
|
|
| B | lowest cutting position is Notch 1. |
| |
|
|
|
|
|
| |
| A |
|
|
|
| |
Figure 5: Adjusting the handle height |
|
|
|
| ||
|
|
|
| 1.25 in | 4.00 in | |
|
|
|
| 3,18 cm | 10,16 cm | |
|
|
|
| Figure 7: Cutting height settings (approximate) | ||
en
13
