3Setting Up the SonicWALL Email Security Appliance
In this section, you will:
•“Apply Power to the SonicWALL Email Security Appliance” on page 10
•“Connect Directly to the SonicWALL Email Security Appliance” on page 10
•“Login to the SonicWALL Email Security Appliance” on page 11
•“Change the Default Administrator Password” on page 13
•“Enter the License Keys for Each Service” on page 14
Apply Power to the SonicWALL Email Security Appliance
1.Plug the power cord into the back of the SonicWALL Email Security appliance and into an appropriate power outlet.
2.Turn on the power switch on the front, top, right corner of the appliance.
The Power LED 
on the front panel lights up green when you power on the
SonicWALL Email Security appliance. The HDD LED 
lights up and may blink while the appliance performs a series of diagnostic tests. When the HDD LED is no longer lit, the SonicWALL Email Security appliance is ready for configuration.
Connect Directly to the SonicWALL Email Security Appliance
The SonicWALL Email Security appliance comes configured with an IP address of 192.168.168.169. Before you can connect your management station to it, you must configure your management station to have an address in the same subnet.
1.Make a note of your computer’s current network settings.
2.Set the computer you use to manage the SonicWALL Email Security appliance to have a static IP address in the 192.168.168.x range, such as 192.168.168.50 and a netmask of 255.255.255.0. For help with setting up a static IP address on your computer, refer to “Configuring a Static IP Address” on page 30.
3.Using the supplied crossover cable and the computer you are using to administer the SonicWALL Email Security appliance, connect the LAN port on the computer to the LAN port on the back of your SonicWALL Email Security appliance.
Page 10
