Resizing and Positioning the Picture
Resizing and Positioning the Picture
You can shift the position of the picture to fit the screen, or adjust the vertical and horizontal size of the picture separately.
Adjusting the Size, Position, or the Pixels of the Picture
Press MENU to show the main menu and adjust “Dot Phase,” “Total H Pixel,” “H Size,” “H Shift,” “V Size,” or “V Shift” on the Adjust Screen menu.
Adjust screen
If there is too much noise on the edges of characters or vertical lines or if the size or position of the picture is improper, adjust the screen.
1 Select “Adjust screen” with M/m and press
ENTER.
The following menu appears on the screen.
SCREEN CONTROL
Adjust Screen |
|
|
|
|
|
Auto Adjust |
|
|
Dot Phase: | 28 |
|
Total H Pixel: | 1344 |
|
H Size: | 50 |
|
H Shift: | 50 |
|
V Size: | 50 |
|
V Shift: | 50 |
|
|
|
|
Select | Set ENTER | Exit MENU |
2 You can adjust the screen either automatically or manually.
Adjusting automatically
(1)Select “Auto Adjust” with M/m and press
ENTER.
The following menu appears on the screen.
SCREEN CONTROL
Adjust Screen |
|
|
|
|
|
Auto Adjust | Cancel |
|
Dot Phase: | OK |
|
Total H Pixel: | 1344 |
|
H Size: | 50 |
|
H Shift: | 50 |
|
V Size: | 50 |
|
V Shift: | 50 |
|
|
|
|
Select | Set ENTER | Exit MENU |
(2)Select “OK” with M/m and press ENTER. All the items of “Adjust screen” menu are adjusted automatically.
Note
Due to patterns in the image, there may be times when noise continues to occur even after you have used Auto Adjust. In such cases, adjust the dot phase manually.
Adjusting manually
(1)Select the item you want to adjust and press
ENTER.
The following appears on the screen. (When you select “Dot Phase”)
SCREEN CONTROL
Adjust Screen |
|
|
Auto Adjust |
|
|
Dot Phase: | 28 |
|
Total H Pixel: | 1344 |
|
H Size: | 50 |
|
H Shift: | 50 |
|
V Size: | 50 |
|
V Shift: | 50 |
|
|
|
|
Select | Set ENTER | Exit MENU |
(2)Adjust the screen with M/m/</,, then press
ENTER.
Dot Phase
Select “Dot Phase” with M/m and press ENTER. Adjust the dot phase with M/m/</, until the characters and vertical lines appear best, then press
ENTER.
Note
This item is valid only for an analog computer signal.
Total H Pixel
Select “Total H Pixel” with M/m and press ENTER. Adjust the total number of horizontal pixels with M/ m/</, until the characters and vertical lines appear best, then press ENTER. (All the items of “Adjust Screen” menu will be readjusted automatically, based on the Total H Pixel that has been adjusted manually.)
Note
This item is valid only for an analog computer signal.
30 (GB)