Location and Function of Parts and Controls

Indicator Section

1 2

Control Button Section (Top)

1 2 3 4 5 6

1 Remote control detector

Receives the signals from the Remote Commander.

2 POWER/STANDBY indicator

Lights up in green when the display unit is powered on. Lights up in red in the standby mode. Lights up in orange when the display enters the power saving mode while a signal is input from a computer.

When the input signal is switched, the indicator blinks green.

When the POWER/STANDBY indicator blinks red, see “Self-diagnosis Function” on page 39 (GB).

1 INPUT button

Press to select a signal to be input from the INPUT or OPTION connector.

The signal to be input switches as follows each time you press the INPUT button.

INPUT1 INPUT2 OPTION1 OPTION2 (only for the FWD-42LX1)

When an option adaptor is not installed in the OPTION slot, OPTION1 or OPTION2 will be skipped.

2 MENU button

Press to show menus. Press again to hide them.

34 m/M (cursor/volume) button

Press to move the cursor (yellow), set a value, or control speaker volume.

5 ENTER button

Press to set your choice.

6 1POWER switch

Press to power on the display unit. Press again to return to the standby mode.

Note

To protect the panel, a certain amount of time is required to turn the unit ON/STANDBY. Wait about 5 seconds after one of these operations before pressing this switch again.

8(GB)