If there is a malfunction, the display shows a message. You can check the condition of the receiver by the message. Refer to the following table to solve the problem.
DEC. ERORAppears when the signal which the receiver cannot decode (ex.
Irregular current is output from the speakers. The receiver will automatically turn off after a few seconds. Check the speaker connection and turn on the power again. If this problem persists, consult your nearest Sony dealer.
If you are unable to remedy the problem using the troubleshooting guideClearing the receiver’s memory may remedy the problem (page 18). However, note that all memorized settings will be reset to their factory settings and you will have to readjust all settings on the receiver.
If the problem persistConsult your nearest Sony dealer.
Reference sections for clearing the receiver’s memoryTo clear | See |
All memorized settings | |
|
|
Customized sound fields | |
|
|
Specifications
AUDIO POWER SPECIFICATIONSPOWER OUTPUT AND TOTAL HARMONIC DISTORTION:
(Model of area code U only)With 6 ohm loads, both channels driven, from 120 – 20,000 Hz; rated 90 watts
Power Output1) |
|
Model of area code U |
|
(6 ohms 1 kHz, THD 10%) | FRONT2): 140 W/ch |
| CENTER2): 140 W |
| SURR2): 140 W/ch |
| SURR BACK2): 140 W |
FRONT2): 110 W/ch | |
| CENTER2): 110 W |
| SURR2): 110 W/ch |
| SURR BACK2): 110 W |
Model of area code CA
(6 ohms 1 kHz, THD 0.7%)
FRONT2): 70 W/ch | |
| CENTER2): 70 W |
| SURR2): 70 W/ch |
| SURR BACK2): 70 W |
(6 ohms 1 kHz, THD 10%) | FRONT2): 110 W/ch |
| CENTER2): 110 W |
| SURR2): 110 W/ch |
| SURR BACK2): 110 W |
1) Measured under the following conditions:
Area code | Power requirements |
U, CA | 120 V AC, 60 Hz |
|
|
2)Depending on the sound field settings and the source, there may be no sound output.
continued