Note
•When you perform [Auto Calibration] in the Easy Setup (page 69), the default settings are changed.
•Depending on the input stream, [Distance] may not be effective.
x[Level]
You can adjust the sound level of the speakers, center speaker, and subwoofer. You can set the parameters from
[Front L/R] 0.0 dB: Set the front speaker level.
[Center] 0.0 dB*: Set the center speaker level.
[Surround L/R] 0.0 dB*: Set the surround speaker level.
[Surround Back L/R] 0.0 dB*: Set the surround Back speaker level.
[Subwoofer] 0.0 dB: Set the subwoofer level.
*This item appears when you set to [Yes] in the [Connection] setting.
x[Test Tone]
The speakers will emit a test tone to adjust [Level].
[Off]: The test tone is not emitted from the speakers.
[On]: The test tone is emitted from each speaker in sequence while adjusting level. When you select one of the [Speaker Settings] items, the test tone is emitted from each speaker in sequence.
Adjust the sound level as follows.
1
2 Press C/X/x/c repeatedly to select the desired speaker and the level.
3 Press .
4 Repeat Steps 1 to 3.
5 Press C/X/x/c repeatedly to set [Test
Tone] to [Off] after adjusting the speaker level.
Note
•The test tone signals are not output from the HDMI OUT jack.
Tip
•To adjust the volume of all the speakers at one time, press 2
By adjusting the remote signal, you can control your TV, a Sony component (such as a VCR, DVD player/recorder, etc.), CATV, or
Note
•When you replace the batteries of the remote, the code number may reset itself to the default (SONY) setting. Reset the appropriate code number.
Preparing the remote for controlling the components
1 Press POP UP/MENU while pressing TV (for TV) or STB (for a Sony component, CATV,
TV or STB (pressed button) flashes.
2 While TV or STB is flashing, enter the manufacturer’s code (see the table) using the number buttons, then press TIME.
If you successfully set the manufacturer’s code, TV or STB will flash twice slowly. If the setting is unsuccessful, TV or STB will flash five times quickly.
Code numbers of controllable components
If more than one code number is listed, try entering them one at a time until you find the code that works with your TV.
TV
Manufacturer | Code number |
SONY | 5001 (default), 5002 |
|
|
AIWA | 5001 |
|
|
AKAI | 5003 |
|
|
DAEWOO | 5003, 5015, 5044 |
|
|
GE | 5003, 5009, 5010, 5044 |
|
|
GOLDSTAR/LG | 5003, 5015, 5017, 5044, 5068 |
|
|
Operations Other