Hookups
Connecting the player to a receiver
Connect the receiver to the i.LINK S200 connector with the i.LINK connecting cable (supplied). Make sure all connections are firm. If not, there will be no sound from the speakers.
| i.LINK S200 |
| i.LINK S200 |
v | v | v | v |
ç: Signal flow
Notes
•Do not connect the mains lead of any component until all the connections have been completed.
•Do not allow any metal object to enter the i.LINK S200 connector as this may
zThe other i.LINK S200 connector can be used to connect other components
The following i.LINK components can be used with the player:
•
•
Be sure to use the Sony i.LINK S200 connecting cable (4 pins - 4 pins).
zFor general information about i.LINK
See “About i.LINK” on page 16.
Connecting the mains lead
Connect the mains lead to a mains.
Removing the protective bar
Remove the attached protective bar and retain it for use when transporting the player at a later time.
§
§
When you connect the mains lead to a mains, the disc tray will close automatically after a while.
Where do I go next?
Now you’re ready to use your player.
If you aren’t familiar with how to play CDs, go to the section “Playing a CD” on page 6.
Then, go to the following sections for other operations.
Getting Started
Attaching the protective bar
When transporting the player, be sure to attach the protective bar (which you removed at the time you unpacked the player) onto the disc tray, and use adhesive tape to secure the bar. If you fail to attach the protective bar, the player may be damaged during transport.
1With the disc tray opened, disconnect the mains lead.
2Place the protective bar on the disc tray as shown below.
x
§
3Push the disc tray with your fingers to close it.
§
Slowly push both sides of the disc tray as shown above.
4Secure the protective bar with adhesive tape.
§
5GB