If you connect an external antenna, connect the ground wire and the AM antenna to the Uterminal. To prevent a gas explosion, do not connect the ground wire to a gas pipe.
Additional Information
Precautions
The nameplate is located on the bottom exterior.
On safety•The glass over the display window on the cover is made of tempered glass.
Under normal conditions, this tempered glass is more shock resistant and able to bear more weight than ordinary glass. This glass, however, may shatter if it receives a sharp blow or if it is scratched.
•The system is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the system itself has been turned off.
•Unplug the system from the wall outlet if it is not to be used for an extended period of time. To disconnect the cord (mains lead), pull it out by the plug. Never pull the cord itself.
•Should any solid object or liquid fall into the system, unplug the system and have it checked by qualified personnel before operating it any further.
•The AC power cord must be changed only at the qualified service shop.
•When you connect the AC power cord to the wall outlet (mains), even though the power is off, the system begins charging for remote and timer functions. Therefore the surface of this unit becomes warm, this is normal.
On placement•Make sure the system fan is on during use. Place the system in a location with adequate air circulation, and do not place anything on the system.
•Place the system in a location with adequate ventilation to prevent heat build up.
•Do not place the system in an inclined position.
•Do not place the system in locations where it is;
—Extremely hot or cold
—Dusty or dirty
—Very humid
—Subject to vibrations
—Subject to direct sunlight.
On installingWhen you move the system, remove the CD.
continued
23