Precautions (continued)
On operation

If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the CD player. Should this occur, the system will not operate properly. Remove the CD and leave the system turned on for about 2 hours until the moisture evaporates.

If you have any questions or problems concerning your system, please consult your nearest Sony dealer.

On the speaker system

This speaker system is magnetically shielded and can be used near TV sets. However, the picture on certain TV sets may become magnetically distorted. In such a case, turn off the power of the TV set once, and after 15 to 30 minutes turn it on again.

If there seems to be no improvement, locate the speaker system further away from the TV set. Also, be sure not to place objects in which magnets are attached or used near the TV set, such as audio racks, TV stands and toys. These may cause magnetic distortion to the picture due to their interaction with the system.

Notes on CDs

Do not use a CD with tape, stickers, or paste on it as this may damage the player.

Before playing, clean the CD with a cleaning cloth. Wipe the CD from the center out. Do not use solvents such as benzine, thinner, commercially available cleaners, or antistatic spray intended for vinyl LPs.

Do not expose the CD to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight.

Cleaning the cabinet

Use a soft cloth slightly moistened with mild detergent solution.

Troubleshooting

If you have any problem using this system, use the following checklist.

First, check that the AC power cord is connected firmly and that the speakers are connected correctly and firmly.

Should any problem persist, consult your nearest Sony dealer.

General

There is no sound.

Press VOL +.

Make sure the headphones are not connected.

Check the speaker connections.

There is severe hum or noise.

A TV or VCR is placed too close to the system. Move the system away from the TV or VCR.

“0:00” (or “0:00AM”) flashes in the display.

A power failure occurred. Set the clock and timer settings again.

The timer does not function.

• Set the clock correctly.

The remote does not function.

There is an obstacle between the remote and the system.

The remote is not pointing in the direction of the system’s sensor.

The batteries have run down. Replace the batteries.

Do not place the system in locations where it is near an electric inverter system.

24