CD Player

The CD cannot be read.

The CD was not placed in the disc tray properly. Place a CD vertically in the tray.

The CD will not eject.

• The CD has tape, stickers, or paste on it.

The CD will not play.

The CD is dirty. Clean the CD with a cleaning cloth.

The face of the CD is scratched. Exchange the CD.

The CD is facing the wrong way.

Moisture condensation has built up. Remove the CD and leave the system turned on for about 2 hours until the moisture evaporates.

Play does not start from the first track.

The player is in program or shuffle mode. Press CD PLAY MODE repeatedly until “SHUF” and “PGM” disappear.

“- OVER -” is displayed.

By pressing M, the last track on the disc has been exceeded. Press and hold (or press repeatedly) m or .to return to a track where playback can begin.

Tuner

Severe hum or noise (“TUNED” or “STEREO” flashes in the display).

Remove the FM antenna from the rear panel and place the antenna outside the cabinet. Adjust the antenna.

The signal strength is too weak. Connect an external antenna.

Make sure the antenna is connected properly.

The AM antenna wire is detached from the stand.

A stereo FM program is not received in stereo.

Press STEREO/MONO so “STEREO” appears.

If other problems not described above occur, reset the system as follows:

1Unplug the AC power cord.

2Hold down ?/1, then plug the AC power cord into the wall outlet again.

The system is reset to the factory settings. All the settings you made, such as the preset stations, clock, and timer are cleared. You should set them again.

Information Additional

25