Step 2: Charging the battery pack

You can charge the battery by attaching the

“InfoLITHIUM” battery pack (P series) to

your camcorder.

bNotes

•You cannot use batteries other than the “InfoLITHIUM” battery pack (P series) (p. 83).

•Do not short-circuit the DC plug of the AC Adaptor or battery terminals with any metallic objects. This may cause a malfunction.

•Use a nearby wall outlet when using the AC Adaptor. Disconnect the AC Adaptor from the wall outlet immediately if any malfunction occurs.

1 Attach the battery pack by sliding it in the direction of the arrow until it clicks.

2 With the v mark on the DC plug facing down, connect the AC Adaptor to the DC IN jack on your camcorder.

3 Connect the power cord to the AC Adaptor.

4 Connect the power cord to the wall outlet.

5 Set the POWER switch to OFF (CHG).

The CHG (charge) lamp lights up and charging starts.

After charging the battery

The CHG (charge) lamp turns off when the battery is fully charged. Disconnect the AC Adaptor from the DC IN jack.

12Getting started