[ON] (p. 45). (Only when connecting to the Windows computer with a USB cable)
The image does not appear on the screen of the Windows computer when using the USB cable.
•The USB driver has been registered incorrectly as the computer was connected to your camcorder before the installation of the USB driver was completed. Follow the procedure below to install the USB driver correctly.
For Windows 98/Windows 98SE/Windows Me
When copying or playing the pictures on a tape using a computer, the operation is not guaranteed on Windows 98.
1 Check that your camcorder is connected to a computer.
2
3 Click the [Device Manager] tab.
4 If the devices below are already installed,
For copying and viewing pictures recorded on a tape
–[USB Audio Device] in the [Sound, video and game controllers] folder
–[USB Device] in the [Other devices] folder
–[USB Composite Device] in the [Universal Serial Bus Controller] folder
5When the [Confirm Device Removal] screen appears, click [OK].
6Turn off the power of your camcorder, disconnect the USB cable, then restart the computer.
7Place the supplied
8 Follow the steps below and try to install the USB driver again. 1
2
* Drive names (such as (E:)) may vary depending on the computer. 3 Click [Open].
4
5
•Deleting anything other than [USB Audio Device], [USB Device] and [USB Composite Device] may cause a malfunction of your computer.
For Windows 2000
Log on as Administrator.
1 Check that your camcorder is connected to a computer.
2
3 Click the [Hardware] tab [Device Manager] [View] [Devices by type].
4 If the devices below are already installed,
Troubleshooting
Continued 71