Note on moisture condensation
Moisture may condense when you bring your camcorder from a cold place into a warm place (or vice versa) or when you use your camcorder in a humid place as shown below.
• When you bring your camcorder from a ski slope into a place warmed up by a heating device.
• When you bring your camcorder from an air conditioned car or room into a hot place outside.
• When you use your camcorder after a squall or a shower.
• When you use your camcorder in a hot and humid place.
How to prevent moisture condensation
When you bring your camcorder from a cold place into a warm place, put your camcorder in a plastic bag and seal it tightly. Remove the bag when the air temperature inside the plastic bag has reached the surrounding temperature (after about one hour).
Video head
•When the video head becomes dirty, you cannot record pictures normally, or distorted picture or sound is played back.
•If the following problem occurs, clean the video heads for 10 seconds with the Sony DVM- 12CLD cleaning cassette (optional).
–
–Playback pictures do not move.
–Playback pictures do not appear or the sound breaks off.
–[Dirty video head. Use a cleaning cassette.] appears on the screen during recording.
–[Dirty video head. Use a cleaning cassette.] appears on the screen during playback.
•The video head suffers from wear after long use. If you cannot obtain a clear image even after using a cleaning cassette, it might be because the video head is worn. Please contact
82 | your Sony dealer or local authorized Sony |
service facility to have the video head replaced.
LCD screen
•Do not exert excessive pressure on the LCD screen, as it may cause damage.
•If your camcorder is used in a cold place, a residual image may appear on the LCD screen. This is not a malfunction.
•While using your camcorder, the back of the LCD screen may heat up. This is not a malfunction.
To clean the LCD screen
If fingerprints or dust make the LCD screen dirty, it is recommended you use a soft cloth to clean it. When you use the LCD Cleaning Kit (optional), do not apply the cleaning liquid directly to the LCD screen. Use cleaning paper moistened with the liquid.
On adjustment of the LCD screen
(CALIBRATION)
The buttons on the touch panel may not work correctly. If this happens, follow the procedure below. It is recommended you connect your camcorder to the wall socket using the supplied AC Adaptor during the operation.
Slide the POWER switch up to OFF (CHG).
Eject the cassette from your camcorder, then disconnect any connecting cables except the AC Adaptor from your camcorder or the Handycam Station supplied with the
Slide the POWER switch down to turn on the PLAY/EDIT lamp while pressing DISP/BATT INFO on your camcorder, then press and hold DISP/BATT INFO for about 5 seconds.
Touch the “×” displayed on the screen with
the corner of the “Memory Stick” or the like.