Step 2: Charging the battery pack

You can charge the battery by attaching the

“InfoLITHIUM” battery pack (F series) to

your camcorder.

bNotes

•You cannot use batteries other than the “InfoLITHIUM” battery pack (F series) (p. 99).

•Do not short-circuit the DC plug of the AC Adaptor with any metallic objects. This may cause a malfunction.

•Use a nearby wall outlet when using the AC Adaptor. Disconnect the AC Adaptor from the wall outlet immediately if any malfunction occurs.

Handycam Station

DC plug

DC IN jack

Power cord

AC Adaptor

To the wall outlet

1 Slide the BATT (battery release) lever in the direction of the arrow as shown in the following illustration and remove the battery terminal cover.

BATT (battery release) lever

2 Attach the battery pack with its terminal side facing your camcorder as shown in the following illustration and

press down the battery pack until it clicks.

3 With the v mark on the DC plug

 

facing up, connect the AC Adaptor to

 

the DC IN jack on the Handycam

Getting

Station.

started

v mark

 

DC IN jack

 

4 Connect the power cord to the AC Adaptor.

5 Connect the power cord to the wall outlet.

6 Insert your camcorder into the Handycam Station.

7 Set the POWER switch to (CHG)OFF.

,continued

Getting started 13