Sony DPP-MP1 17 GB, Printing, duplicates, To turn off DPOF mode, Changing the number of, 3Press the ENTER button, 2Change the number of duplicates

To cancel the operation while printing is in progress

If you have specified several prints but want to cancel the operation before it is completed, press the PRINT/STOP button. The indication “WAIT” appears on the display, and printing stops after the current print is finished.

If unit runs out of paper or print cartridge ribbon while printing

If the unit runs out of paper while printing, the indication “PAPER” flashes on the display. If the print cartridge ribbon runs out, the indication “RIBON” flashes on the display.

To continue the current operation, load print paper or replace the print cartridge without turning the unit off. Press the PRINT/STOP button to resume printing.

To turn off DPOF mode

To turn off the DPOF mode after printing, press the DPOF button once more. The indication “DPOF” disappears from the display and the normal indication is shown again.

Changing the number of

duplicates

The number of duplicates for a Print Mark image that has been set with the digital camera can be changed on the DPP-MP1. To do this, perform the operation described below after step 3 in the section “Bulk printing of images with Print Mark” (page 15). The unit must be in DPOF mode (“DPOF” indication shown on display).

1Select the Print Mark image for which you want to make the change.

Use the SELECT (–/+) buttons to call up the file number of the desired image. Then press the ENTER button. The indication for the number of duplicates flashes and can now be changed.

DPOF

2Change the number of duplicates.

Use the SELECT (–/+) buttons to set the number.

3Press the ENTER button.

The new number of duplicates is now active.

Printing

Continued

17 GB