Sony DPP-SV88 operating instructions Preparing the remote commander, Replacing batteries, 21 GB

Models: DPP-SV88

1 344
Download 344 pages 293 b
Page 21
Image 21

2Preparing the remote commander

1Remove the friction seal from the remote commander.

With the friction seal removed from the lithium battery, the remote commander is ready for use.

Friction sea

2 Point the remote commander to the remote sensor on the

printer and then press a button to operate the printer.

You can use the buttons on the remote commander in the same way as those identical buttons on the printer.

Remote sensor

Setting up

Replacing batteries

When the printer does not respond to the remote commander, the battery may run out. Use a fine pin or other thin shaped device to pick and slide out the battery compartment lid. Remove the used battery and then insert a new lithium battery (CR2025) into the compartment with the + and – properly aligned.

Lithium battery

CAUTION:

Replace the battery with Sony CR2025 lithium battery. Use of another battery may preset a risk of fire or explosion.

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions.

21 GB

Page 21
Image 21
Sony DPP-SV88 Preparing the remote commander, Replacing batteries, Remove the friction seal from the remote commander