cConnect the supplied USB multi connecting cable to the
multi connector of the camera.
Multi connector
v mark
•When placing the camera, make sure the LCD screen is facing up.
dConnect the USB multi connecting cable to your computer.
•When using a desktop computer, connect the USB multi connecting cable to the USB connector on the rear panel.
72
eTurn on the camera.
•When using Windows XP, the AutoPlay wizard automatically appears on the desktop. Proceed to page 75.
USB MODE
NORMAL
Access indicators*
“USB MODE NORMAL” appears on the LCD screen of the camera. When a USB connection is established for the first time, your computer automatically runs the used program to recognize the camera. Wait for a while.
•If “USB MODE NORMAL” does not appear, confirm that [USB CONNECT] is set to [NORMAL] in the SET UP settings (page 99).
*During communication, the access indicators turn red.
PDisconnecting the USB multi connecting cable from your computer, removing the “Memory Stick” from the camera, or turning off the camera
Disconnecting the USB multi connecting cable from your computer/removing the “Memory Stick” from the camera/turning off the camera
For Windows 2000, Me, or XP users
1
2Click (Sony DSC), then click [Stop].
3Confirm the device on the confirmation window, then click [OK].
4Click [OK].
This step is unnecessary for Windows XP users.
5Disconnect the USB multi connecting cable from your computer, remove the “Memory Stick” from the camera, or turn off the camera.
For Windows 98 or 98SE users
Confirm that the access indicators on the LCD screen are turned white and carry out only Step 5 above.