Symptom

Cause

Solution

The battery remaining

• You have used the camera for a long time in an

—

indicator is incorrect, or

extremely hot or an extremely cold location.

 

sufficient battery

• A deviation has occurred in the remaining

p Fully discharge and then charge the battery pack so that the

remaining indicator is

battery time.

battery remaining indicator functions correctly (page 11).

displayed but the power

• The battery pack is discharged.

p Install a charged battery pack (page 10).

runs out soon.

• The battery pack is dead (page 110).

p Replace the battery pack with a new one.

 

 

 

The battery pack runs

• You are shooting/viewing images in an

—

down too quickly.

extremely cold location.

 

 

• The DC plug is dirty so the battery pack is not

p Clean the pins of the AC Adaptor with a cotton swab, etc., and

 

charged enough.

charge the battery pack (page 10).

 

• The battery pack is dead (page 110).

p Replace the battery pack with a new one.

 

 

 

You cannot turn on the

• The battery pack is not installed correctly.

p Install the battery pack correctly (page 10).

camera.

• The AC Adaptor is disconnected.

p Properly connect the AC Adaptor (page 13).

 

• The battery pack is discharged.

p Install a charged battery pack (page 10).

 

• The battery pack is dead (page 110).

p Replace the battery pack with a new one.

 

 

 

The power turns off

• If you do not operate the camera for about 90

p Turn on the camera again (page 14) or use the AC Adaptor

suddenly.

seconds while the power is on, the camera turns

(page 13).

 

off automatically to prevent wearing down the

 

 

battery pack (when [Power Save] is [Off] after

 

 

three minutes) (page 14).

 

 

• The battery pack is discharged.

p Install a charged battery pack (page 10).

 

 

 

Shooting still images/movies

Symptom

Cause

 

Solution

The LCD screen is not

• The power was turned off with the LCD screen

p Turn on the LCD screen (page 28).

turned on even when the

turned off the last time you used the camera.

 

power is turned on.

 

 

 

 

 

 

 

The subject is not visible

• The mode dial is set to

or SET UP.

p Set it to other modes (pages 21 and 68).

on the LCD screen.

 

 

 

 

 

 

 

88