Editing onto another tape
Using the i.LINK cable (DV connecting cable)
Simply connect the
DV | S VIDEO LANC |
DV IN/OUT
DV IN/OUT
ç: Signal flow
Notes on editing when using the i.LINK cable (DV connecting cable)
•You can connect one VCR only.
•You can record picture, sound and system data at the same time on the DV products by using the i.LINK cable (DV connecting cable) only.
•You cannot edit the titles, display indicator or the contents of cassette memory.
•If you record playback pause picture with the DV IN/OUT jack, the recorded picture becomes rough. And when you play back the picture using the other video equipment, the picture may jitter.
•You can also use the camcorder as a recorder with this connection. In this case “DV IN” indicator appears on the screen.
•When you use the camcorder as a recorder, the color balance may be incorrect on the monitor screen. But this is not recorded on the tape.
To perform a more precise editing
Use DV
Starting editing
(1) Insert a blank tape (or a tape you want to record over) into the VCR, and insert your recorded tape into the camcorder.
(2) Play back the recorded tape on the camcorder until you locate the point where you want to start editing, then press Pto set the camcorder in playback pause mode.
(3) On the VCR, locate the recording start point and set the VCR in recording pause mode.
(4)Press Pon the camcorder and VCR simultaneously to start editing.
To edit more scenes
Repeat steps 2 to 4.
To stop editing
Press ¹on both the camcorder and the VCR.
operations Advanced
83