WRR-855A/855B

Set the AUDIO IN switch to WIRELESS.

For the operation of the WRR-855A/855B, refer to the manual supplied with the WRR-855A/855B.

Notes

•When the XLR connection automatic detection function is on, even if the AUDIO IN CH-1 or CH-2 switch is set to WIRELESS, the signal input to the AUDIO IN CH1 or CH2 connector is automatically selected when an audio cable is connected to the AUDIO IN CH1 or CH2 connector. In such a case, set REAR XLR AUTO to OFF on the AUDIO-1 page of the MAINTENANCE menu.

•The audio signals to be recorded on audio channels 3 and 4 depend on the settings of the AUDIO IN CH-3/CH-4 switches without being affected by the XLR connection automatic detection function.

 

Fitting the WRR-862 (with a battery pack)

 

 

1 (1)Attach the WRR tuner fitting (not supplied, service

 

 

 

 

 

 

 

 

7Chapter

part number: A-8278-057-A) to the back of the

camcorder.

 

Battery Pack

Adjustment screws

Mount plate (supplied with WRR-862)

Back of camcorder

Screwdriver

2 Mount the tuner on the WRR tuner fitting.

WRR-862

3 Connect the tuner power cord to the DC OUT connector of the camcorder, and the audio output cable to the AUDIO IN CH1 or CH2 connector.

Setting

1 Use a Phillips-type screwdriver to tighten the

four screws placed in the tuner fitting. For three

of these screws, insert the screwdriver through

Up

the corresponding hole and tighten the screw.

the

 

Camcorder

2 Loosen the adjustment screws.

3 Adjust the tuner fitting position for a battery

pack to be attached, and tighten the adjustment

 

 

screws to fix its position.

4Attach the mount plate supplied with the WRR- 862.

(2)Attach the battery pack.

For details about attaching the battery pack, see “7-1- 1 Using a Battery Pack” on page 108.

AUDIO IN CH-1/CH-2 switches: When the XLR connection automatic detection function is set to OFF on the AUDIO-1 page of the MAINTENANCE menu, set the AUDIO IN CH-1 or CH-2 switch for the channel to which the audio output cable is connected to REAR.

LINE/MIC/+48 V ON switch:

Set the LINE/MIC/ +48 V ON switch for the channel to which the audio out cable is attached to MIC.

to AUDIO IN CH1 or CH2 connector

to DC OUT connector

116 Audio Input System