Controls and Parts of Functions and Locations 2 Chapter
B (ATW): When this switch is set to B and on the FUNCTION 2 page of the OPERATION menu, “WHITE B CH” is set to “ATW”, ATW is activated.
When this switch is adjusted, the new setting appears on the setting change/adjustment progress message display area of the viewfinder screen for about 3 seconds.
You can assign the ATW ON/OFF function to the ASSIGN 1 switch (push button) on the FUNCTION 1 page of the USER menu.
For details, see
uTURBO GAIN button
When shooting under extremely poor lighting conditions, press the button once to boost the video gain to the value preset on the GAIN SW page of the USER menu (up to 48 dB). To stop boosting the gain, press the button once more.
vVIDEO OUT connector | wTEST OUT connector |
| xREMOTE connector |
Shooting and recording/playback functions (3)
vVIDEO OUT connector (BNC type)
This connector outputs a composite video signal (standard level,
By installing the
For details on how to select the output signal, see
wTEST OUT connector (BNC type)
This connector outputs the video signal (standard level, 75- ohm terminated) for a video monitor. The output signal can be selected from composite or RGB. The factory setting is
composite, and the setting returns to composite whenever the unit is powered on.
Depending on menu settings, menus, time code, and shot data can be superimposed on the image on the monitor.
For details on how to select the test output signal, refer to the Maintenance Manual.
xREMOTE connector
Connect the
22 | Shooting and Recording/Playback Functions |
|
|