|
|
| |||||
|
|
|
|
|
|
|
|
|
| Independent data | |||||
|
| region | |||||
|
| MASTER BLACK | |||||
|
| MASTER GAMMA | |||||
|
| ||||||
Setup | KNEE POINT | ||||||
menu of the | DETAIL LEVEL | ||||||
camcorder | R/B GAIN |
|
|
|
| ||
| |||||||
|
| R/B BLACK |
|
| |||
|
|
| |||||
Hardware of
the camera
Remote control data
MASTER BLACK |
|
|
|
MASTER GAMMA |
|
|
|
KNEE POINT |
| ||
DETAIL LEVEL |
| ||
| connected | ||
R/B GAIN |
| ||
|
|
| |
R/B BLACK |
| ||
|
| connected | |
For details on menu operations, see
To keep the video quality before a remote control unit is connected
Set RM COMMON MEMORY to ON on the FUNCTION 3 menu of the MAINTENANCE menu, and set all the volume on the remote control unit to the relative value mode. After making these settings, connect the remote control unit.
For details, refer to the operation manual supplied with the remote control unit.
Thus, when a remote control unit is connected to the camcorder, the effective data region is switched to the “remote control data region” and the settings of the paint adjustment that were in effect last time the remote control unit was used are recalled.
Settings of the absolute value volume 1) and absolute value switches 2) are overwritten by those on the remote control unit after the remote control unit is connected.
When the remote control unit is removed from the camcorder, the “independent data region” becomes effective. Thus the camcorder will return to the settings that were in effect before the remote control unit was connected.
1)Absolute value volume
The data corresponding to the rotation degree (position) of the volume knob is output. The data corresponding to the rotation amount (change) is called the relative value volume.
2)Absolute value switch
Toggle switches or slide switches (except the temporary switches) (or controls) whose positions must coincide with their functions are called absolute value switches.
To use settings of the paint adjustment data stored in the “independent data region” even when you disconnect a remote control unit
Set RM COMMON MEMORY to ON on the FUNCTION 3 page of the MAINTENANCE menu.
In this case, the settings stored in the “independent data region” will be renewed according to the change of settings in the “remote control data region.” Thus, the settings of the paint data made with the remote control unit can be retained even if the remote control unit is removed. However, if the switch position on the remote control unit differs from the one on the camcorder, the switch position on the camcorder takes precedence over that on the remote control unit.
Camcorder the Up Setting 7 Chapter
Connecting the Remote Control Unit | 121 |
|
|