When the external battery begins to fail and an internal battery pack is not used
First load the camcorder with a fully charged internal battery pack, then remove the DC output cable of the external battery from the DC IN connector. The power source will switch to the internal battery pack. To use an external battery again, connect a fully charged external battery to the DC IN connector before unloading the internal battery pack. The power source will switch to the external battery.
Continuous operation when operating with only an internal battery pack
First, connect a fully charged external battery to the DC IN connector, then change the internal battery.
Notes
•When an internal battery pack is loaded and an external battery is connected to the DC IN connector, the external battery is always used as the power source.
•There may be some noise on the video signal at the instant the power sources are switched.
to an AC power source
Connecting to an AC power source
using the
By fitting the camcorder with the Anton Bauer Ultralight system, and setting the LIGHT switch to AUTO, you can switch the light on and off automatically as you start and stop VTR operation. This system operates with lights powered by 12 V, with a maximum power consumption of 50 W.
Using the
Connect the camcorder to the AC power supply through the
to an AC power source
AC Adaptor | Power switch on |
| |
| |
550CE |
|
| DC OUT |
DC IN
DC output cable (supplied with the
Using an AC adaptor
Using the
Mount the
Camcorder the Up Setting 7 Chapter
Power Supply 109