Sony FWD-50PX1 ENTER, ENTER, ENTER, 3 Press ENTER, Adjusting the Pixels, Adjusting the Picture Position, </, : Move the picture left and right

Resizing and Positioning the Picture

Adjusting the Picture Position

1 In the Screen Control menu, press M/m to move the cursor (yellow) to “Screen Shift” and press

ENTER.

The following menu appears on the display panel.

H	S h i	f	t	0 0
V	S h i	f	t	0 0

2 The M/m/</, buttons move the picture vertically and horizontally.

</, : Move the picture left and right

M/m : Move the picture up and down Horizontal picture position is displayed on the screen with adjustment values ranging from LEFT

(128)to RIGHT (127). Vertical picture position is displayed on the screen with adjustment values ranging from BOTTOM (128) to TOP (127). The factory preset value is 00.

3 Press ENTER.

The menu returns to the Screen Control menu.

Adjusting the Pixels

If there is too much noise on the edges of the characters or the vertical lines, you can adjust the dot phase and the total number of horizontal pixels.

Note

This item depends on the computer signal being used.

1 In the Screen Control menu, press M/m to move the cursor (yellow) to “Adjust Pixel” and press

ENTER.

The following menu appears on the display panel.

S c r e e n C o n t r o l

A d j u s t P i x e l

A u t o	A d j u s t
D o t	P h a s e
T o t a l H P i x e l		:	1 3 4 4
R e s e t
,	t o s e l e c t ,	ENTER ,	t o
s e t

2 You can adjust the dot phase and the total number of horizontal pixels automatically or manually.

Adjusting automatically

(1)Select “Auto Adjust” with M/m and press

ENTER.

The following menu appears on the display panel.

S c r e e n C o n t r o l
A d j u s t P i x e l
	A u t o A d j u s t			C a n c e l
	D o t	P h a s e		O K
	T o t a l H P i x e l		:	1 3 4 4
	R e s e t
,		t o s e l e c t	,	p r e s s ENTER
	t o	r e t u r n

(2)Select “OK” with M/m and press ENTER. The dot phase and the total number of horizontal pixels are adjusted automatically.

36 (GB)