Controlling Power On/Off Automatically (Timer Function) /Self-diagnosis Function

Power Saving Function

1 In the Timer/Clock menu, press M/m to move the cursor (yellow) to “Auto Shutoff” and press

ENTER.

The following menu appears on the display panel.

 

T i m e r / C l o c k

 

 

 

 

 

 

C l o c k

S e t

 

 

 

 

 

 

C l o c k D i s p l a y :

O f f

 

 

 

O n / O f f T i m e r

:

 

O f f

 

 

 

A u t o S h u t o f f

:

O f f

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

5 m i n

 

 

 

 

 

 

 

 

1 0 m i n

 

 

 

,

t o

s e l e c t ,

 

p r e s s

ENTER

 

 

 

 

 

 

 

 

 

t o

r e t u r n

 

 

 

 

2 Press M/m to select the length of time until the change to power saving mode.

Off : The power saving function does not work.

5min : Changes to the power saving mode after five minutes if there is no input signal.

10min : Changes to the power saving mode after ten minutes if there is no input signal.

When the power saving mode is on, the unit changes to standby mode.

Note

Self-diagnosis Function

The unit has a self-diagnosis function.

This function shows the display’s condition based on the pattern shown by the flashing of the POWER/ STANDBY indicator. The flashing pattern informs you of the display’s current condition.

If the POWER/STANDBY indicator flashes, check the number of flashes and contact your authorized Sony dealer.

1 Check the flashing pattern of the POWER/ STANDBY indicator.

The indicator flashes (with an image showing on the display) or flashes at intervals of three seconds (with no image showing on the display).

Count the number of flashes if the indicator flashes at intervals of three seconds. For example, the indicator flashes twice, followed by a three second pause, two more flashes and this pattern repeats. In this case, the count for the number of flashes is two.

2 Unplug the unit.

Inform your authorized Sony dealer of the number of flashes.

The power saving function is available only when a video signal or a component signal is being received. When RGB is selected and the display receives no RGB signal for more than 30 seconds, the display enters the standby mode and the POWER/STANDBY indicator lights up in orange. Once an RGB signal is input to the selected INPUT, the power is automatically restored and the picture shows on the screen. (PC power saving mode)

To cancel the power saving function

Press the 1 (POWER) switch on the Control Button section or the POWER ON switch on the Remote Commander.

44 (GB)