Parts of Function and Location 2 Chapter
To access the switch panel, open the lower control | On how to open the lower control panel, see the figure on | |
panel. | page | |
|
|
|
| 1 CONTROL PANEL connector | |
|
| CONTROL PANEL |
KEY INHI | PANEL SEL |
|
ON OFF REAR FRONT
2 PANEL SELECT switch
3KEY INHI switch
4Memory stick slot
1 CONTROL PANEL connector | 4 Memory stick slot | |
type) | Use this to update the firmware. You can also save or | |
Plug in the lower control panel connection cable. | load setup menu settings onto the memory stick. | |
|
| |
2 PANEL SELECT switch | Note |
|
In addition to the lower control panel, you can connect a similar control panel to this unit. When two control panels are connected to the unit, the PANEL SELECT switch is used to specify which panel be enabled to control the unit.
FRONT: Enables the control panel connected to the CONTROL PANEL connector on the switch panel.
REAR: Enables the control panel connected to the CONTROL PANEL connector on the connector panel. When setup menu item 117 is set to PARA, this switch position also enables the control panel connected to the CONTROL PANEL connector on the switch panel.
3KEY INHI switch
Moving this switch to the ON position disables the controls on the upper and lower control panels.
You can specify which buttons and knobs are disabled in setup menu item 118.
After inserting a memory stick, allow at least five seconds to elapse before removing it.
For details on firmware update and save or load setup menu settings, refer to the Maintenance Manual Volume 1.
Chapter 2 Location and Function of Parts |