To avoid short-circuiting the speakers

Short-circuiting may damage the speakers and cause a malfunction.

Make sure the stripped ends of each speaker cord does not touch the stripped end of another speaker cord.

Examples of poor conditions of the speaker cord

Stabilizing speakers

To prevent speaker vibration or movement while listening, attach the supplied foot pads at the bottom of the speakers. If you are using the speaker stand (not supplied), you do not need to attach them.

Using speaker stand (not supplied)

When using separately sold speaker stand (WS-FV10C, WS-TV10C, WS-WV10C), you can easily configure your speaker layout.

7:Attaching the jack cover and stand

You can use the control center laid flat, or in an upright position by attaching the supplied stand to the rear or side of the control center. You can also install the control center on the wall. Besides, you can change the item layout in the display according to the layout of the control center (page 16).

Attaching the jack cover

1 Gather all the connecting cords together.

2 Attach the jack cover carefully so as not to pinch the cords. Then fix the jack cover with the supplied screws using the hexagonal wrench.

Started Getting

WS-WV10C (Wall use)

WS-FV10CWS-TV10C

Notes

Make sure that the connecting cords are not trapped by the jack cover.

If you use commercially available cords, it is recommended that you use cords similar in size to the cords provided with this system. If the cords are too thick or stiff, or the plug is too large, you may not be able to attach the jack cover securely. If you cannot attach the jack cover, you do not have to attach the jack cover.

continued

11GB